Fenix Everyday Carry Torch E12 V3.0 Black Mini Keychain Flashlight Max 200 Lumens, Head: 0.76" (19.3mm), Max 78m Beam Distance, Powered by 1 x AA Alkaline Battery. One-Hand Operate by Tail Switch, 1 x AA Battery is Included. 5 Years Free Re

Warning

 - Do NOT place this small EDC flashlight within children's reach!
 - Do NOT shine the flashlight directly into anyone's eyes!
 - Do NOT place the flashlight near flammable objects; high temperatures can cause objects to overheat and become flammable/ignite!
 - Do NOT use the flashlight in inappropriate ways such as holding the unit in your mouth, doing so could cause serious personal injury or death if the flashlight or internal battery fails!
 - This flashlight will accumulate a significant amount of heat while operating, resulting in a high temperature of the flashlight shell. Pay close attention to avoid burns.
 - Turn off and lock the light or take out the battery to prevent accidental activation during storage or transportation.
 - The LED of this good EDC flashlight is not replaceable, so the whole flashlight will need to be replaced when the LED reaches the end of its lifespan.

Warranty: 5-Years Free Repair Warranty (Battery for 1 year)!

The Fenix E12 V3.0 is a lightweight portable EDC flashlight.Powered by a single AA battery, the flashlight has a maximum output of 200 lumens and can throw a beam up to 78 meters to meet your lighting needs. Battery power will not be consumed in standby status,which provides sufficient power for each use.Two-way body clip and magnetic tail allow for convenient and hands-free use. Additional highlights include tail standing capability and IP68-rated protection. Whether you are on the job or on the go the Fenix E12 V3.0 will always be there to light the way.

 - 200 lumens maximum output and 78 meters maximum beam distance.
 - Uses one Luminus SST20 LED with a life span of 50,000 hours.
 - Included by a single AA battery, easy to find.
 - No standby current, safe and cost-efficient.
 - One-handed operation with the single tail switch.
 - Magnetic tail for hands-free use.
 - Two-way body clip and tail standing capability for various conditions.
 - Made of durable A6061-T6 aluminum.
 - Premium type HAIII hard-anodized anti-abrasive finish.

Operating Instructions:

On/off

Fully press the tail switch to turn on/off the light.

Output selection

With the light switched on, tap the tail switch to cycle through Low?Med?High.

Intelligent Memory Circuit

The light memorizes the previously used output level, each time it is turned on, the previously used output level will be activated.

Battery Specifications

Battery Replacement

Unscrew the light body and insert the battery with the anode side (+) towards the light head, then screw the light body back on.

Usage and Maintenance

 - Disassembling the sealed head can cause damage to the light and will void the warranty.
 - Fenix recommends using an excellent-quality battery. 
 - Removing the battery or electrolyte leakage could damage the lamp if the light is not used for an extended period.
 - Unscrew the tail cap half a turn or remove the battery to prevent accidental activation during storage or transportation.
 - Long-term use can result in O-ring wear. Replace the ring with an approved spare to maintain a proper water seal.
 - Periodic cleaning of the battery contacts improves the lamp's performance and keeps it the best EDC flashlight. Dirty contacts may cause the light to flicker, shine intermittently, or even fail to illuminate for the following reasons:

A: The battery needs replacing.
Solution: Replace battery (Ensure battery is inserted according to the manufacturer's specifications).

B: The threads, PCB board contact, or other contacts are dirty.
Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.